Inspect The Thermostat
This is the top place to search for a problem. It's quite possible that you don't have heating system difficulty at all. The heater will not run unless it gets the command from the thermostat.
Furnace repair salt lake city
Make certain your thermostat circuitry isn't broken anywhere along the line to the heater. If you happen to find any breaks, an easy splice that's wrapped with electrical tape will supply a short-lived repair.
Get rid of the thermostat cover and carefully check for loose circuitry. Your thermostat should be sitting level and securely attached. Get rid of any dust.
Make Sure The Furnace Is Powered
HVAC contractors salt lake city
You do not wish to spend for a heater repair work call if all that's needed is the turning of a switch. Make sure the power switch to the heating system is 'on'. It looks like any typical wall switch and you'll discover it situated either on the heating system or on a close-by wall.
Be sure the circuit breaker line or the fuse to the furnace is delivering power.
Examine the panel that sits over the blower motor. The furnace can't run if it isn't securely closed. When it's in the correct position, it depresses a switch that enables it to work.
Change The Heater Filters
Heating and cooling repair salt lake city
The primary cause of heater operating failure is clogged filters that trigger getting too hot and premature shut-off. You'll know this is the problem if the blower motor is running but there's no heat coming through.
Examine the gas furnace handbook to find the filter, find out how to effectively remove it and pick the replacement size/type.
Please note that a clogged up, soot-laden filter results in a dirty heat exchanger as well. Performance is considerably minimized and the furnace can sustain life-shortening damage. Replace cheap filters on a monthly basis throughout the heating season. Check pleated filters every couple of months and change them as needed.
Is The Gas Switched on?
Don't neglect this action even if it seems too incredible. It's possible that somebody deliberately turned the gas valve into the 'off' position for some reason and after that forgot to turn it back on.
If your gas line has a levered deal with, make sure it's located parallel to the pipe. If it's perpendicular, it's turned 'off'.
An older furnace most likely has a pilot burner. Get rid of the panel on the front of the gas furnace and after that get rid of the cover to the burner. Aesthetically check to see of the pilot is lit.
Flush The Drain Lines
Furnaces that are extremely efficient drain gallons of water every day. Make certain there's no mold or dirt build-up that's shutting your heater down.
Cleaning up the drain hose is easy. Just remove the tube, fill it with water which contains 25% bleach and let it sit for several minutes. Flush it out and put it back into place.
Look For Restricted Air Circulation
When your furnace is running but some spaces remain cold, be sure that any air registers are totally open.
Check the ductwork for spaces or breaks. Seal them with a special duct tape that's made of metal.
While you're at it, watch for any levers that might be jutting out from the ductwork. These dampers must be in the 'open' position.
Check For Blocked Consumption Or Exhaust Vents
This is applicable if your gas furnace is vented on the side of your home. Ensure the vents are completely clear of any particles.
Likewise, if there's a heatpump, check for particles build-up near the outside compressor fins.
While these DIY heating system repair work pointers can conserve you money, there will be times when you need to call on an expert gas furnace repair specialist. Don't be neglected in the cold. Put our reliable, considerate, licensed heating specialists to work for you.
404 Ironwood Drive
Salt Lake City, UT 84115
Post a Comment